Factors Involved in Chimney Repair Process


Posted April 2, 2022 by cochimney

The caps come in various designs and styles, like ones that are aerodynamic to reduce any downdraft from the passing winds and breezes. The cap also comes with many other features, including a solid top.

 
The caps come in various designs and styles, like ones that are aerodynamic to reduce any downdraft from the passing winds and breezes. The cap also comes with many other features, including a solid top.

But sometimes the fire you burn will send creosote particles out and they have been known to accumulate within the cap that could eventually block the proper flow of air needed.

When doing the Chimney Repairs, the main goal is to clean off the built up creosote that can be a huge issue for most metal caps.

• The first step is to put on some shoes with rubber soles and some clothes that will fit loosely on you. Then you will want to set up your ladder - preferably an extension ladder that will extend to about three feet above the ease to allow a safer way to climb onto the roof. Don't forget to bring a Phillips screwdriver and a wrench as these tools are the most important for this job.

• If you lift the Chimney Crowns off and it is attached to the flue, you need to locate the screws and unscrew them using your screwdriver. Then you can use the wrench to hold the nuts steady during this part, provided there are nuts. This will allow you to be able to take the cap down to make any necessary repairs in your garage.

• One way to remove the built up creosote is to use a chisel and a hammer as a way of scraping it from the cap's sides. It's probably a good idea to wear protective gloves to keep your hands protected from the creosote. When you have chipped all of it off, you can collect what you have removed into a bag for disposal in the garbage can.

• While you have it detached, you have a chance to repair any joints that might have been separated. This can be done by screwing them back together with the use of self-tapping sheet metal screws. Afterwards, you can clamp that joint by using a C-clamp followed by using a drill and a No. 2 drill bit to drive the screw. On a side note, there's no need to create any predrilled holes since the self-tapping screws will do that for you.

If you are looking for Chimney Inspections service, then contact https://www.cochimney.com/



Colorado Chimney Company

4319 Sheridan

Loveland, CO

80538

Phone: (970) 786-6400

Email: [email protected]
-- END ---
Share Facebook Twitter
Print Friendly and PDF DisclaimerReport Abuse
Contact Email [email protected]
Issued By Addams
Phone (970) 786-6400
Business Address 4319 Sheridan Loveland, CO
USA
Country United States
Categories Business
Tags chimney crowns , chimney relining
Last Updated April 2, 2022