This is a basic bit by bit methodology for sticking a rubber onto a cutting edge without the guide of any unique instruments or hardware. It can likewise be utilized to supplant your current rubbers with new ones.

All you really want is some table tennis stick (VOC based paste or rubber concrete), a ballpoint pen, an exceptionally sharp cutting blade or disposable cutter and a hard round tube-like roller, (for example, a wine bottle), a piece of cardboard and a heap of weighty books.

Sticking system:

Put the rubber on the edge and with a pen draw (on the back on the wipe, NOT the top-sheet) around the edge of the bat to generally show which parts of the rubber should be stuck (ensure the piece with the logo on the rubber is simply over the handle.
Apply paste aside of the cutting edge spreading it out equally. You can utilize a piece of rubber slice off to spread it out, or wrap your finger inside a piece of plastic and spread it that way.
Likewise apply paste to the rubber spreading it out equitably inside the lines drawn before.
Delay until the paste on the rubber is contact dry, ordinarily somewhere around 5mins.
Apply one more slender layer of paste on the rubber as in the past (assuming your paste is now very thick, this progression isn't needed)
Delay until the paste on the rubber is contact dry once more.
Get the rubber, tenderly put in onto the sharp edge arranging the base part (logo end) first (simply over the handle), and afterward put down the rest.
Utilize a hard round article, for example, a wine bottle, and delicately turn it over the rubber to ensure it's pushed down onto the cutting edge appropriately. HARD CHROME ROLLER https://rubberrollermanufacturer.com/
Put the cutting edge and rubber onto a table with rubber at the base, and utilize an exceptionally sharp blade to remove the abundance rubber around the edge of the edge. Putting a piece of cardboard under the rubber makes it simpler to cut, as the blade can really cut into the paper a bit. Try not to attempt to slice through the rubber in one pass, go over each cut a few times before it's sliced through, which gets a much cleaner cut.
Whenever completed roll down the rubbers once more, and spot it under a pile of books for several hours or so to ensure it bonds appropriately. To keep the rubbers clean, you should put a few plastic over them (like the plastic cover that accompanied the bundling) which likewise safeguards the surface.
Focus on any pieces of rubber from the edges, and set off tape whenever required.
This basic method ought to guarantee a flawless and appropriate connection of your rubber to your cutting edge. On the off chance that you're not content with the outcome, you can continuously pull the rubbers off once more, and yet again stick it, despite the fact that arranging it is a little trickier when the rubber is cut.