Cleaning and assembly of TIMKEN bearings

The good TIMKEN turntable bearing assembly, set with the set and parts are not

interchangeable between column and column. TIMKEN bearing apart when cleaning, should

according to the bearing assembly drawing, BEST Bearing upper and lower half ring should be according to

the original position drilling assembly. Tooth surface shall be once every 10 days to remove

debris, and coated with grease. Bearing lubrication, because of the large comprehensive work

factors, the user can according to the specific requirements to choose the best grease.
Bearings after installation, according to the actual conditions of use, filling and optimum

grease, and should be filling while slewing bearing grease evenly distributed, until the new

oil began to squeeze out the sealing lip. Once every 50 ~ 100 hours filling, under the

condition of high environmental dust and ash more grease cycle should be shorter. Machine

before and after the stop over a long period of time, must also add new grease
Good way of TIMKEN bearing import cleaning and assembly can prolong the life of TIMKEN

bearing import.